수치는 몰라서 대충 험
정확한 수치 아는사람 알려주면 각잡고 해봄
i dont know about exact size, so i did it roughly
먼저 노브.
가운데 각인이 있으면 강조되게끔, 없어도 밋밋허지 않게 가운데를 오목하게 만들고 12개의 홈을 팜
first, knob modeling.
i designed it if there is logo in center, it could be highlighted. and avoid unispirng if there is no logo
미끄럼 방지 없는 버전
without non-slip spinning
있는버전. 너무 작게 만들어지지가 않아서 커짐 ㅅㅂ
미끄럼 방지를 진짜 작게 만들고 세로로 4줄, 가로로 2줄 씩 홈에 맞춰서 만들먄 이쁠 것 같음
with non-slip spinning
i would design it smaller if i could,
그담 접안렌즈 언저리
and somewhere near ocular lense
홈은 2개씩 45도당 하나, 총 8세트
큰거 하나는 배율 조정 기준점이라 해야하나 그거 ㅇㅇ
돌기에 홈 파져 있는건 스호우 레버가 딱 맞게끔 함과 동시에 킹작권을 피하기 위한 몸부림임
one set of spinning per 45 degrees, large one is for centering.
groove in center of spinning is for throw lever . and avoid violating copyright
대충 이런 토대로 만들면 존나 이뿔 것 같은데
밑에서 본 버전